1. Keep the controller connected, press BACK & B & Home to enter calibration mode.

2. The Indicator LEDs will flash alternately as red.

3. Rotate both left and right sticks clockwise for 3 full rotations and fully press both left and right triggers three times at a consistent speed.

4. Place the controller on a flat surface and press the “B” button.

5. Calibration completes as the controller automatically enters motion sensor calibration (indicated by flashing blue LED), then the controller will power off automatically.

Click here to watch calibration tutorial

1. Open the firmware, and after a successful wired connection, press and hold X + Y + HOME. 

2. The controller's indicator light will turn off, indicating successful entry into update mode. 

3. Then click ""Update"" to proceed. 

(If the controller does not power on after entering update mode, close the firmware, reopen it, and retry the update.)

a.2.4G Reciver For PC

1. Insert the receiver into a USB port on your PC.

2. Slide the ‘Mode Toggle’ to the (2.4 Ghz) Mode

3. Press the Home button to power on.

4. The controller’s LED will flash (indicating pairing). 

 When the LED becomes steady with a short vibration to confirm pairing.

Forced Pairing (if auto-reconnection fails):

1. Insert the wireless receiver into a USB port on your PC, press and hold the

 receiver's button for 1 second until its LED flashes rapidly.

2. With the controller powered off, press and hold the Home button for 5

 seconds to power on.

3. The LED will flash rapidly, then become steady with a short vibration to

 confirm pairing.

b.Wired connection PC

1. Slide the Mode Toggle to the (2.4 GHz) mode.

2. Connect the controller to the PC using a USB cable.

c.Bluetooth connect for Phone

First-Time Connection:

1. Slide the Mode Toggle to the BT (Bluetooth) mode.

2. Press and hold the Home button for 5 seconds to power on.

3. The controller’s LED will flash (indicating pairing).

4. Enable Bluetooth on your phone, then search for “Xbox Wireless Controller”

 and select it to pair.

5. When the LED becomes steady with a short vibration to confirm pairing.

Reconnection:

Keep the Mode Toggle under BT Bluetooth mode, and short-press the

 Home button to reconnect your phone.

e.Connect to Switch

While in 2.4GHz connection mode, you can switch between controller modes:

Long-press BACK & START Button for 3 seconds to cycle through:

① X-input mode (white LED)

② D-input mode (yellow LED)

A short vibration confirms a successful mode switch.

1. While connected, press and hold Right Stick & O button for 2 seconds to

 switch between “zero dead zone” and “with dead zone” modes.

2. The default setting is “with dead zone.”

Deadzone Adjustment

1. While connected, press and hold Left Stick & O button for 2 seconds to

 switch the axis boundary between “circle” and “square” modes.

2. The default axis boundary is “circle.”

While the controller is powered on and connected (in any mode), press and hold the HOME + BACK + START buttons for 5 seconds.

All lights will turn off and the controller will restart, indicating the factory reset was successful.

(There is no vibration prompt.)